Real questions from real riders — setup problems, bike shopping, gear, technique — answered by riders, tuners, and shops. Search before you ask — your answer may already be here. New to riding? Ask anything; you don't need a bike in your garage.
Leave the fork baseline alone first — a damper shouldn't change your spring/clicker starting point. The lazy turn-in is the damper adding low-speed resistance. Back the damper off a touch and re-evaluate before you chase it in the forks.
Chatter that shows up specifically on power exit over ripples is usually rebound returning too fast — the tire unloads and re-grips in a cycle. Slow rear rebound 1–2 clicks first. If the ride height sags a lot under load, then revisit spring, but rebound is the cheap first move.
Start with fork compression: back it out 2 clicks and ride a session before touching anything else. Harsh over sharp bumps with mid-corner push is almost always high-speed compression too firm. Keep rebound where it is for now so you isolate the change.
That is everything here today. 5 questions, 3 solved. Ask one and it lands in front of riders on the same bike.